Smart Design. Smart Build with Polyguard.

Project Profile

Perot Museum of Nature & Science

Dallas, Texas

Perot Museum of Nature & Science
Opened in December 2012, this $185 million dollar, 180,000 square foot museum stands 170 feet high in Dallas, Texas. The museum is located on a 4.7 acre former brownfield site, north of downtown Dallas, and houses five floors devoted to the public, 11 permanent exhibit halls, a 298 seat multimedia cinema with state of the art 4K digital projection and a public café and event catering group managed by Wolfgang Puck. The building incorporates sustainable design including low emission materials, LED lighting and day lighting. A rainwater collection system that captures run off into two 25,000 gallon cisterns satisfies three quarters of the Museum's non potable water needs and all of its irrigation needs.



Architect:
Thom Mayne; 
Morphosis Architects, Inc.
Culvercity, California


General Contractor:
Balfour Beatty Construction
Dallas, Texas


Waterproofing Contractor:
Alpha Insulation & Waterproofing
Grapevine, Texas

Perot Museum of Nature & Science incorporates the following Polyguard Products:

-

Waterproofing Systems

Underseal® Blindside™ Membrane - 73 mil, pre-concrete pour waterproofing membrane used for vertical positive side waterproofing

Underseal® Underslab Membrane - 85 mil pre-concrete pour waterproofing membrane/vapor barrier that provides a continuous seal

 

Drainage Systems

Polyflow® 15 / 15P - Prefabricated geocomposite vertical use drainboard with a compressive strength of 15,000 psf